![]() ![]() After every pass, thoroughly clear off any slag.To avoid undercutting, weld side-to-side.Maintained a quick travel quality and reduced welding parameters by approximately 10% – 15% when welding overhead. Hold your gun at a 90-degree work angle for flat locations or butt welds with a 180-degree joint.One straight weld at 60° to 70° on a lap joint.Welding at a 90-degree angle and ten degrees back for such a flat weld.The wire that is 1/2′′ to 3/4′′ long protrudes.The arrow in the picture above shows you the button. You’ll find only 0.035 is available to you when you pick gasless welding with flux core welding wire. Press and the light toggles between 0.023, 0.030, or 0.035. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |